Toshiba 57HX93 Owners Manual - Page 52

Chapter 6: Setting up your TV Viewing the digital signal meter Checking system status You can view the digital signal meter for ANT 1 and ANT 2 digital TV input sources only. To view the digital signal meter: 1. Press MENU and open the SETUP menu. 2. Highlight INSTALLATION and press ENTER. (A new set of INSTALLATION menu icons will appear on-screen, as shown in step 3 below.) To check the system status: 1. Press MENU and open the SETUP menu. 2. Highlight INSTALLATION and press ENTER. (A new set of INSTALLATION menu icons will appear on-screen, as shown in step 3). 3. Open the SYSTEM STATUS menu, highlight SYSTEM INFORMATION, and then press ENTER. Setup Installation Sleep Timer On/Off Timer Digital Tuner Hold Off Slide Show Interval 2 Sec Convergence 3. Open the TERRESTRIAL menu, highlight SIGNAL METER, and press ENTER. Terrestrial Input Configuration Channel Program Channel Add/Delete Signal Meter 4. Use the yzx • buttons to select the antenna input and digital channel whose signal you want to check. Note: The digital channel number listed in the Signal Meter screen does not correspond to an actual TV channel number. Contact your local broadcasters to obtain the RF channel numbers for your local digital stations. Signal Meter Signal Unlocked 0 Antenna Channel (Digital) OK Peak 0 1 1 Signal Meter Signal Unlocked 0 Antenna Channel (Digital) OK Peak 0 1 134 To close the screen and return to the TERRESTRIAL menu: Highlight OK and press ENTER. To return to normal viewing: Press EXIT. Setup Installation Sleep Timer On/Off Timer Digital Tuner Hold Off Slide Show Interval 2 Sec Convergence System Status System Information 4. Use the x • buttons to scroll through the menu bar to check the Product Information and Software Version. System Information System Information Product Information Brand: Model: IEEE-1394 GUID: Toshiba 57H93 0000391428343803 OK Software Version 1.0.7 Jul 21 2003 - 16:31:05 FW 2.1 OK To close the screen and return to the TERRESTRIAL menu: Highlight OK and press ENTER. To return to normal viewing: Press EXIT. Restore Factory Defaults To restore all settings and channels to their factory default values: 1. Follow steps 1-3 above. 2. Use the x • buttons to scroll through the menu bar to select FACTORY DEFAULTS. 3. The screen below left appears. Enter your PIN code (or 0000 if no PIN code has been set). The screen below right appears. To cancel the reset: Highlight NO and press ENTER. To continue the reset process: Highlight YES and press ENTER. The TV will turn off automatically after a few seconds. After the TV turns off, unplug the TV power cord and then plug it in again to complete the restore. System Information System Information Factory Defaults This window provides the ability to reset the TV settings. Type in your PIN now (or "0000" if no PIN has been set) to restore settings to their factory default values. OK Factory Defaults This window provides the ability to reset !the TV settPinrgesss. YES to confirm. After the TV turns off, unplug it and plug it Type in youbracPkINinntoowco(morp"le0t0e0t0h"e irfensoet.PIN has been set) to restore settings to their factory default valuesY.es No OK 52 Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.