Toshiba 65H93 Owners Manual - Page 42

Chapter 6: Setting up your TV Programming channels into the TV's channel memory When you press CHANNEL y or z on the remote control or TV front panel, your TV will stop only on the channels stored in the TV's channel memory. Follow the steps below to program channels into the TV's channel memory. Programming channels automatically Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels. Note: • If you already programmed channels automatically during the Quick Connect Guide assisted setup, you can skip to "Manually adding and deleting channels in the channel memory" on the next page. • You must configure the antenna input sources before programming channels (see page 41). • The automatic channel programming process does NOT erase channels that were previously programmed into the TV's memory, but adds newly found channels to the existing set of programmed channels. To remove a channel from the memory, you must manually delete it (see next page). • To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. • Programming channels for an antenna input configured for CABLE will take substantially longer than for an antenna input configured for ANTENNA. This is normal; however, once channel programming is completed, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly. To program channels automatically: 1. Make sure you have configured the antenna input sources. See page 41 for details. 2. Press MENU and open the SETUP menu. 3. Highlight INSTALLATION and press ENTER. (A new set of INSTALLATION menu icons will appear on-screen, as shown in step 4). 5. Highlight ANT 1 or ANT 2, depending on which antenna input you want to program channels for, and then press ENTER to start automatic channel programming. Terrestrial Input Configuration Channel Program Channel Add/Delete Signal Meter ANT 1 ANT 2 i ANT 1 Cable Scanning channels, please wait... 0% Abort The TV will automatically cycle through all the channels for the antenna input you selected, and store all active channels in the channel memory. While the TV is cycling through the channels, the message "Scanning channels, please wait" appears (as shown above right). To cancel channel programming, highlight ABORT and press ENTER. 6. When channel programming is done, press CHANNEL y or z to view the programmed channels. (Continued on next page) ACTION MENU +10 - 100 THEATER NET Channel Numbers FAV ENTER CHANNEL y z + PAGE - Setup Installation Sleep Timer On/Off Timer Digital Tuner Hold Off Slide Show Interval 2 Sec Convergence 4. Open the TERRESTRIAL menu, highlight CHANNEL PROGRAM, and press ENTER. TV front panel MENU VOLUME CHANNEL EXIT TV/VIDEO TouchFocus CHANNEL z / y 42 Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.