Toshiba A100 VA3 Maintenance Manual - Page 253
Replacing TDM fluorescent lamp10, The PCB GND-CU shall be within the bezel.
UPC - 623506014649
View all Toshiba A100 VA3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
4 Replacement Procedures 4.25 Fluorescent lamp 4. Bezel set 1) Hook the upper side (TAB side) of bezel to the three latches of frame. • 2) Latch the side. 3) Mate the lamp side. , Caution: 1. Do not damage the TAB. 2. Make sure the three latches of bezel are hooked. 3. The PCB GND-CU shall be within the bezel. PCB GND-CU shall be within bezel. Folding of reflector shall be within bezel. PCB GND-CU shall be within the bezel. Figure 4-53 Replacing TDM fluorescent lamp(10) 4-66 PORTEGE A100 Maintenance Manual (960-460)
4 Replacement Procedures
4.25
Fluorescent lamp
4-66
PORTEGE A100 Maintenance Manual (960-460)
4.
Bezel set
<Procedure>
1)
Hook the upper side (TAB side) of bezel to the three latches of frame.
°
2)
Latch the side.
3)
Mate the lamp side.
±
Caution:
1. Do not damage the TAB.
2. Make sure the three latches of bezel are hooked.
3. The PCB GND-CU shall be within the bezel.
Folding of reflector
shall be within bezel.
PCB GND-CU shall be
within bezel.
PCB GND-CU shall
be within the bezel.
Figure 4-53
Replacing TDM fluorescent lamp(10)