Toshiba SD-4100 Owner's Manual - English - Page 20

DVD Menu Options English Night Mode C This mode optimizes playback of sound at low volume. High volume outputs will be softened and low volume outputs are brought upward to an audible level. A In ＇ Audio＇, press  /  to select { Night Mode }, then press . D { On } Select this to set low volume output. This feature is only available for movie discs with Dolby Digital mode. E { Off } Turns off night mode feature. Select this to enjoy the surround sound with its full dynamic range. B Use  /  to select a setting and press OK to confirm. Down Sampling You can enable and disable the digital signal for better sound output quality. A A In ＇Audio＇, press  /  to select { Down Sampling }, then press . B { Off } If your amplifier / decoder is compatible with 96 KHz PCM, select " Off " . Sound is sampled at 96 KHz. C { On } If your amplifier / decoder is not compatible with 96 KHz PCM, select " On " . Sound recorded at 96 KHz is down sampled to 48 KHz. B Use  /  to select a setting and press OK to confirm. Tip: - When playing back disc with copyright protection, the sound will be down sampled to 48 KHz even when you select Down Sampling off. 3D Effects To obtain expansive virtual surround sound effects from two speakers, set 3D Effects to on. This enhancement sounds only output from the Analog AUDIO OUT (L / R) jacks of the DVD player. A In 'Audio', press  /  to select { 3D Effects }, then press .You can set to { Off } or { On }. B Use  /  to select a setting and press OK to confirm. Tip: D - Only effective in playback of a DVD Video disc with Dolby Digital 5.1 bitstream. Using the Rating setup menu A Press SETUP on the remote control. The system setup menu appears. Language Video Audio Parental control : 8.Aduit Set Password Rating Misc B Press  /  to select {Rating }, then press . Helpful hint: Press  to go back to previous menu item. Press SETUP to exit the menu item. Press  /  to select an item, then press  to access. Example: { Parental control } The options for the selected item appears. If the selection in the menu is greyed out, that means the feature is not available or not possible to change at the current state. Use  /  to select a setting and press OK to confirm. Example: { 8 Adult } The setting is selected and setup is completed. To exit, press SETUP. Rating Level settings Depending on the DVD, you may be asked to change the parental level while playing the disc. The rating levels are from 1 to 8 and are country dependent. You can prohibit the playing of certain discs that are not suitable for your children, or have certain discs played with alternative scenes. In ' Rating ', press  /  to select {Parental control }, then press . Use the number buttons to enter the four-digit password, then press OK.(See 'Changing the Password' on page 20.) Press OK again to list the parental level. { 1.Kid Safe } Suitable for children. { 2. G } General Audience; recommended as acceptable for viewers of all ages. { 3. PG } Parental Guidance suggested. { 4. PG-13 } Unsuitable for children under 13. { 5. PG-R } Parental Guidance Recommended. { 6. R } Restricted; under 17 requires accompanying parent or adult guardian. { 7. NC-17 } No one under 17 admitted. { 8. Adult } DVD softwares of any grades (adult/general/children) can be played back. Should be viewed only by adults due to graphic sexual material, violence or language. Use  /  to select a rating level and press OK to confirm. Select { 8 Adult } to disable parental level and allow all discs to play. DVDs that are rated higher than the level you selected will not play unless you enter your four-digit password. Tips: -This feature will not limit viewing if the disc manufacturer did not code the disc. -VCD, SVCD, CD have no level indication, so parental control has no effect on these type of discs. This also applies to most illegal DVDs. -Some DVDs are not coded with a rating though the movie rating may be printed on the disc cover. The rating level feature does not prohibit play of such discs. 19