Toshiba SD-5915 Owners Manual - Page 46

Others Operating a TV with the Remote Control You can operate the basic functions of selected TVs using the supplied remote control Operating a TV with the remote control Preparation Follow the instruction of "To program the remote control" to set the brand code. Point the remote control at your TV, and use buttons as follows. POWER INPUT SELECT NUMBER buttons 100 • DISPLAY VOL + / CH +/ ENTER To turn the TV on or off. To select external source such as a VCR. To select TV channel. When selecting channels 1 to 9, first enter 0 and then the desired number. To substitute for 100 channel key. To turn on or off TV's screen display. To adjust the volume. To select a channel. To use for the TV's ENTER key. To program the remote control 1 Press TV to select TV mode. 2 While holding down PROGRAM enter the two digits of your TV's brand code (listed on page 47) using Number buttons. e.g. To program brand code 01. PROGRAM 01 Note When using the remote control, press the buttons at intervals of about 1 second to ensure the correct mode of operation. 3 Release PROGRAM. The DVD remote control memorizes the selected TV brand code. POWER INPUT SELECT Numbers/100 • DISPLAY CH, VOL PROGRAM ENTER Notes • The remote control is programmed at the factory to operate TOSHIBA TVs. • A single brand may use different codes depending on the particular model. Enter the correct number referring to the brand code table. • For some brands, several brand codes are provided. Try each of them until the remote control operates your TV. • Some TVs may not respond to all of the functions in the table above, or may not be operated at all with this remote control. • If you replace the remote control's batteries, remember to reprogram the brand codes for TV. • Press DVD back if DVD operation is required. 46