Toshiba SDP94SKN Owners Manual - Page 26

Preparation of the remote control Preparations Insert the specified battery to the remote control. See page 8 for safe use of coin-shaped batteries. 1 Gently insert a fingernail in groove 1 and pull out the holder in direction 2 . Backside 1 Operating with the remote control Point the remote control at the remote sensor and press the buttons. 2 Take care not to break your fingernail. 2 Place a coin-shaped battery (CR2025) with the side up on the holder. CR2032V5 Keep the holder horizontal so that the battery does not fall through. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 3 26 Insert the holder into the remote control. The remote control battery contains Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate Within about 9.9 feet (3 m) Distance: About 9.9 feet (3 m) from the front of the remote sensor Angle: About 30° in each direction of the front of the remote sensor Do not expose the remote sensor of the player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the player via the remote control. • Do not drop or give the remote control a shock. • Do not leave the remote control near an extremely hot or humid place. • Do not spill water or put anything wet on the remote control. • Do not disassemble the remote control. • If the remote control does not function correctly or if the operating range becomes reduced, replace the battery with new one. • Inserting a battery other than the specified one or an object may damage the remote control. 4%14,/@&@JOEE