Toshiba SDV280 Owners Manual - Page 13

Introduction Inserting Batteries 1 Open the battery compartment cover in the direction of the arrow. 2 Install two "AAA" batteries (supplied), paying attention to the polarity diagram in the battery compartment. 3 Replace the compartment cover. Battery precautions The precautions below should be followed when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re- versed batteries may cause damage to the device. To avoid a potential short circuit, insert the "-" end first. 3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones. 4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions.) Remote control basics • Press POWER ( ) to turn the DVD/VCR on or off. • Select your desired operating mode (DVD or VCR) using DVD/VCR. (DVD or VCR indicator on the front panel will show you which mode is selected.) • Press CH or CH to move through the channels one channel at a time. • The CH / ( / ) and SET +/- ( / ) are also used to navigate on-screen menu system. • You can directly access specific channels using Number buttons. • Each press of DVD/VCR on the remote control, switches the screen between the VCR screen (VCR mode) and the DVD screen (DVD mode). Operation • Aim the remote control at the remote sensor and press control buttons to operate. • Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of Approx. 7 meters. Approx. 7 meters 13