Troy-Bilt Big Red Operation Manual - Page 38

Service

Get Troy-Bilt Big Red PDF manuals and user guides View all Troy-Bilt Big Red manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Service 7 Belt Replacement Drive Belt 5. Lift the top half of the belt up and over the upper pulley and the rubber reverse disc, moving it in front of the reverse disc. See Figure 7-3. 1. Move the Wheels/Tines/PTO Drive Lever to NEUTRAL position. 2. While kneeling on the right side of the tiller, create slack in the belt by reaching over to the left side of the pulleys and pushing in on the center of the belt with your finger. 3. Use your right hand to move the belt down and away from the lower pulley, in the direction of the engine. See Figure 7-1. Drive Belt Lower Pulley Reverse Disc Drive Belt Figure 7-3 6. Push the Wheels/Tines/PTO Drive Lever down into the FORWARD position. This increases the distance between the upper and lower pulleys. Next, lift and pull the entire belt out from between the pulleys. See Figure 7-4. Figure 7-1 4. Push the belt upward to create slack in the belt. See Figure 7-2. Push Belt Up Figure 7-2 38 Pulley Drive Belt Figure 7-4 7. Place the Wheels/Tines/PTO Drive Lever in FORWARD position. 8. Squeeze the belt in the middle and insert one end in between the pulleys. See Figure 7-4.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Service
7
38
Belt Replacement
Drive Belt
1.
Move the Wheels/Tines/PTO Drive Lever to NEUTRAL
position.
2.
While kneeling on the right side of the tiller, create slack in
the belt by reaching over to the left side of the pulleys and
pushing in on the center of the belt with your finger.
3.
Use your right hand to move the belt down and away from
the lower pulley, in the direction of the engine. See Figure 7-1.
Drive Belt
Lower Pulley
Figure 7-1
4.
Push the belt upward to create slack in the belt. See Figure 7-2.
Push Belt Up
Figure 7-2
5.
Lift the top half of the belt up and over the upper pulley
and the rubber reverse disc, moving it in front of the
reverse disc. See Figure 7-3.
Drive Belt
Reverse Disc
Figure 7-3
6.
Push the Wheels/Tines/PTO Drive Lever down into the
FORWARD position. This increases the distance between
the upper and lower pulleys. Next, lift and pull the entire
belt out from between the pulleys. See Figure 7-4.
Pulley
Drive Belt
Figure 7-4
7.
Place the Wheels/Tines/PTO Drive Lever in FORWARD
position.
8.
Squeeze the belt in the middle and insert one end in
between the pulleys. See Figure 7-4.