Troy-Bilt Pro-Line CRT Operation Manual - Page 18
Transmission, Housing, Cover, Hex Screw
View all Troy-Bilt Pro-Line CRT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
4. Remove all dirt and clean the area around the transmission cover. See Fig. 7-3. Hex Screw Transmission Cover Transmission Housing Figure 7-3 5. Remove the four hex screws (5⁄16-18 x .75) securing the transmission cover to the drive shaft and remove the cover. See Fig. 7-3 6. Remove the left-side wheel. Tilt the left-side wheel shaft into a drain pan and allow the gear oil to drain through the top of the transmission. 7. Reinstall the wheel and reinstall the transmission cover. 8. Refill the transmission using Mobil 1® Synthetic 75W 140. Refill the engine with motor oil and replenish the fuel tank with gasoline. 9. Reinstall the belt cover. 18 Section 7- Service
18
S
ECTION
7— S
ERVICE
4.
Remove all dirt and clean the area around the transmission
cover. See Fig. 7-3.
Figure 7-3
Transmission
Housing
Transmission
Cover
Hex Screw
5.
Remove the four hex screws (²⁄³6
-18 x .75) securing the
transmission cover to the drive shaft and remove the cover.
See Fig. 7-3
6.
Remove the left-side wheel. Tilt the left-side wheel shaft
into a drain pan and allow the gear oil to drain through the
top of the transmission.
7.
Reinstall the wheel and reinstall the transmission cover.
8.
Refill the transmission using
Mobil 1®
Synthetic 75W 140.
Refill the engine with motor oil and replenish the fuel tank
with gasoline.
9.
Reinstall the belt cover.