Uniden BC340CRS English Owners Manual - Page 22

Bank 6 51 52 53 54 55 56 57 58 59 60 Bank 7 61 62 63 64 65 66 67 68 69 70 Bank 8 71 72 73 74 75 76 77 78 79 80 Bank 9 81 82 83 84 85 86 87 88 89 90 Bank 10 91 92 93 94 95 96 97 98 99 100 Once you fill out the above chart, follow these steps to enter or change a frequency in a memory: 1. Press E/PGM to enter the program mode (the scanner turns on the PGM icon). 2. If the current channel is not the one you want to program, enter the memory number then press HOLD. 3. Enter the frequency including the decimal point, then press E/PGM. 4. To program the next memory, press L or M and repeat step 3. To program a different memory, repeat from step 2. 5. To exit program mode, press HOLD or SCAN or change the scanner's mode. Notes: • Any frequency you program replaces the previous memory contents. • If you enter a frequency you have already stored in a different memory in Step 3, the scanner beeps and displays the channel where you have previously stored the frequency. If you want to store the frequency anyway, press E/PGM a second time in Step 3. • To clear the contents of a memory, enter "0" in Step 3. • Channels you program are automatically unlocked (see "Locking/Unlocking Memories) and have Delay turned on (See "Setting Channel Delay"). Selecting a Memory To select a single memory to monitor, press HOLD. The scanner turns on the HOLD icon. Then, select a memory by pressing L or M to go to the memory or input the memory number then press HOLD. Using the Scanner Memories 22