Uniden BC345CRS English Owner's Manual - Page 22

BANK 1 BANK 2 BANK 3 4 54 104 5 55 105 6 56 106 7 57 107 8 58 108 9 59 109 10 60 110 Follow these steps to enter or change a frequency in a memory: 1. Press E/PGM to enter the Program mode (the scanner turns on the PGM icon). 2. If the current channel is not the one you want to program, enter the channel number then press HOLD. 3. Enter the frequency, including the decimal point, and then press E/PGM. 4. To program the next channel, press ▲ or ▼ and repeat step 3. To program a different channel, repeat from step 2. 5. To exit Program mode, press HOLD or SCAN or change the scanner's mode. Notes: • Any frequency you program replaces the previous channel contents. • If you enter a frequency you have already stored in a different channel in Step 3, the scanner beeps and displays the channel where you have previously stored the frequency. If you want to store the frequency anyway, press E/PGM a second time in Step 3. • To clear the contents of a channel, enter 0 in Step 3. • Channels you program are automatically unlocked (see "Locking/ Unlocking Channels) and have Delay turned on (See "Setting Channel Delay"). Selecting a Channel To select a single channel to monitor, press HOLD. The scanner turns on the HOLD icon. Then, select a channel by pressing ▲ or ▼ to go to the channel or input the channel number then press HOLD. Scanning Memory Banks To scan the channels you have programmed, press SCAN. The scanner scans all unlocked programmed channels in enabled memory banks, stopping on a channel when it detects a transmission. To turn on/off channel banks while scanning, press the number button that corresponds to the channel bank you want to enable or disable. 22