Uniden DC11 English Owner Manual - Page 10

Powering Up The Dc11

Get Uniden DC11 PDF manuals and user guides View all Uniden DC11 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

the edge of the microSD card inwards for it to pop out and then pull it out of the slot. POWERING UP THE DC11 Only use the DC car adapter that comes with your device. Any other adapter might damage the device. 1. Refer to your car's owner's manual to verify where the power outlets are on and around the dashboard. Locate an outlet that supplies 12V electric power when the key is in the ON or ACC position. 2. Connect the car adapter to the camera and to the that power outlet. 3. Start the car. The camera turns on automatically and begins recording. (Press OK to stop recording.) When the car's engine is turned off, the camera will automatically turn off in a few seconds. Charge the camera for at least 15 minutes after it is turned on for the first time or after it has been turned off for more than three weeks. 4. At other times, press the button to turn it on. Press and hold the button to turn it off. The unit charges the battery whenever power is detected through the USB port. When the unit is being charged, the red LED glows. It will automatically turn off when the unit has been charged completely. The unit will take about 90 minutes to charge completely. The Battery Status icon tells you how full the battery is. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
10
the edge of the microSD card inwards for it to pop out
and then pull it out of the slot.
POWERING UP THE DC11
Only use the DC car adapter that comes with your
device. Any other adapter might damage the device.
1.
Refer to your car’s owner’s manual to verify where
the power outlets are on and around the dashboard.
Locate an outlet that supplies 12V electric power
when the key is in the ON or ACC position.
2.
Connect the car adapter to the camera and to the
that power outlet.
3.
Start the car. The camera turns on automatically
and begins recording. (Press
OK
to stop recording.)
When the car’s engine is turned off, the camera will
automatically turn off in a few seconds.
Charge the camera for at least 15 minutes after it is
turned on for the first time or after it has been turned
off for more than three weeks.
4.
At other times, press the
button to turn it on.
Press and hold the
button to turn it off.
The unit charges the battery whenever power is detected
through the USB port. When the unit is being charged,
the red LED glows. It will automatically turn off when
the unit has been charged completely. The unit will take
about 90 minutes to charge completely. The Battery
Status icon tells you how full the battery is.