Uniden DC360 English Owner Manual - Page 8

Attaching The Windshield Mount, Powering Up The Dc360

Page 8 highlights

using a good quality microSDHC card of at least 16GB capacity (included) and minimum Class 10 speed. Insert a formatted microSD card gently in the slot on the side of the unit. To remove the card from the slot, press the edge of the microSD card inwards for it to pop out and then pull it out of the slot. ATTACHING THE WINDSHIELD MOUNT 1. Before removing the plastic cover on the wind- shield mount adhesive pad, place the unit on the windshield and adjust the cameras until the viewing angles are good for the forward and rear views. The mounting pad adhesive is a permenant adhesive; you cannot adjust it once it has been placed. 2. Remove the plastic cover on the windshield mount. 3. Position the windshield mount on the windshield and press the unit against the windshield. Tighten the nut. 4. Readjust the cameras if necessary. POWERING UP THE DC360 Only use the DC car adapter that comes with your device. Any other adapter might damage the device. 1. Refer to your car's owner's manual to verify where the power outlets are on and around the dashboard. Locate an outlet that supplies 12V electric power when the key is in the ON or ACC position. 2. Insert the car adapter into a power outlet. 3. Connect the camera to the car adapater through the microUSB port. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

8
using a good quality microSDHC card of at least 16GB
capacity (included) and minimum Class 10 speed.
Insert a formatted microSD card gently in the slot on the
side of the unit. To remove the card from the slot, press
the edge of the microSD card inwards for it to pop out
and then pull it out of the slot.
ATTACHING THE WINDSHIELD MOUNT
1.
Before removing the plastic cover on the wind-
shield mount adhesive pad, place the unit on the
windshield and adjust the cameras until the viewing
angles are good for the forward and rear views.
The mounting pad adhesive is a permenant adhesive;
you cannot adjust it once it has been placed.
2.
Remove the plastic cover on the windshield mount.
3.
Position the windshield mount on the windshield
and press the unit against the windshield. Tighten
the nut.
4.
Readjust the cameras if necessary.
POWERING UP THE DC360
Only use the DC car adapter that comes with your
device. Any other adapter might damage the device.
1.
Refer to your car’s owner’s manual to verify where
the power outlets are on and around the dashboard.
Locate an outlet that supplies 12V electric power
when the key is in the ON or ACC position.
2.
Insert the car adapter into a power outlet.
3.
Connect the camera to the car adapater through the
microUSB port.