Uniden DCT748-2 English Owners Manual - Page 25
Setting the Dial Mode
View all Uniden DCT748-2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
GETTING STARTED Setting the Dial Mode Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing; the default setting is tone dialing. Set the dialing mode to match the dialing system used by your local phone service. • If you are not sure of your dialing system, make a trial call. If the call connects, leave the setting as is; otherwise set the unit to pulse dialing. • If your phone system requires pulse dialing and you need to send DTMF tones in certain situations during a call, you may switch over to tone dialing (refer to "Tone Dialing Switch-over" on page 32). 1)Press menu/clear. Select the Global Setup menu, and then the Dial Mode submenu. 2) Press /vol/∧ or /vol/∨ to select Tone or Pulse (the initial setting is Tone). &KCN/QFG 6QPG 2WNUG 3) Press select/ /audio tone. You will hear a confirmation tone. www.uniden.com GETTING STARTED [24]