Uniden DFR1 Product Guide - Page 2

CITY CITY 1 X K Ka L C C+ X K Ka L C C+ X K Ka L C C+ X K Ka L C C+ OPERATION SETUP After installing your radar detector, you can set it to your own specifications. • Mute/Auto Mute. When an audio alert sounds, pressing MUTE lets you turn off the audio alarm. Press and hold MUTE to set Auto Mute to ON to reduce the audio alarm by 50% automatically after 3 seconds during an alert. • Dim. Change the brightness of the display. (Default Bright) • Set City, City I, or Highway --City mode delays all X band audio alerts until the signal is at level 2. --City I mode does not recognize X band transmissions. --Highway mode recognizes all bands and is recommended for highway driving. (Default) The following table provides an overview of key operations. KEY PRESS TO... PRESS AND HOLD TO... MUTE Turn alert audio off (1 beep) during alert audio. Mute cancelled 10 seconds after alert ends. Turn Auto Mute on (1 beeps) and off (2 beeps) during standby. DIM Change brightness NA from: BRIGHT (3 beeps) to DIM (1 beeps) to DARK (2 beeps). CITY Change mode from: NA HIGHWAY (3 beeps) to CITY (1 beeps) to CITY I (2 beeps). DIM + NA Return to factory CITY settings: • Highway • Bright • Mute OFF • Auto Mute ON MONITORING SPEED A radar gun transmits radio waves at certain frequencies that bounce off objects and return to the radar gun's receivers. The radar gun then calculates the speed of the object. The DFR1 recognizes the following bands/frequencies used by radar guns: BAND X K Ka Laser FREQUENCY 10.525 GHz 24.150 GHz 33.400 - 36.000 GHz 800 nm - 1100 nm RADAR DETECTOR DETECTORS (RDD) Radar detectors are illegal in some states. Law enforcement officers use special equipment to detect signals radiated by radar detectors. If they are in a state where radar detectors are illegal and the officer detects a vehicle using a radar detector, the operator of that vehicle could lose the radar detector and be fined. The DFR1 is designed to be invisible to signals from the Spectre l, Spectre lV, and VG-2 RDDs. CARE AND MAINTENANCE Use common sense and your DFR1 will provide trouble-free service. Please keep the following tips in mind: • Don't leave your unit on the dashboard during summer months. Interior heat may exceed safe operating levels. • Do not spray cleaners or other liquids on the unit. Remove the unit when you are using these liquids. • Do not use abrasive cleansers on the unit's exterior. TROUBLESHOOTING IF... TRY THIS... No display or audio. Check the fuse in the plug. Replace if necessary. The unit alarms when the vehicle hits bumps. Check the connections. Be sure they are all secure. The unit alarms There may be a motion sensor or briefly in the same house alarm in use within range. location but no radar source was in view. The detector did not The officer may not have radar/ alert when a police laser units turned on. car was in view. SPECIFICATIONS Receiver Type: Radar Double Conversion Superheterodyne Self-Contained Antenna Laser Pulsed Laser Signal Receiver Frequency: X 10.525 GHz K 24.150 GHz Ka 33.400 - 36.000 GHz Laser 800 nm - 1100 nm Detector Type: Radar Scanning Frequency Discriminator Laser Pulse Width Discriminator Alarm Type Beep (Detected Band and Signal strength) Antenna Type: Radar Linear Polarized E-vector Vertical Laser Front Convex Condenser Lens Laser Back Concave Condenser Lens Dimensions 110.00 mm (D) x 69.00 mm (W) x 29.50 mm (H) Weight 3.4 oz (95g) Operating Temp. -4° to +185° F (Radar/Laser) -20° to +85° C (Radar/Laser) Storage Temp. -22° to +203° F (Radar/Laser) -30° to +95° C (Radar/Laser) Operating DC 11.0 to 16.0 V Power Soure FCC/Industry Canada Information FCC: AMWDLRD350 ICC: 513C-LRD350 FCC Compliance This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. Avis de conformité à la FCC : Ce dispositif a été testé et s'avère conforme à l'article 15 des règlements de la Commission fédérale des communications (FCC). Ce dispositif est soumis aux conditions suivantes: 1) Ce dispositif ne doit pas causer d'interférences nuisibles et; 2) Il doit pouvoir supporter les parasites qu'il reçoit, incluant les parasites pouvant nuire à son fonctionnement. Tout changement ou modification non approuvé expressément par la partie responsable pourrait annuler le droit à l'utilisateur de faire fonctionner cet équipement. IC Compliance This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. Cet appareil est conforme aux normes RSS exemptes de licences d'Industrie Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d'interférences nuisibles et (2), il doit pouvoir accepter les interférences, incluant celles pouvant nuire à son fonctionnement normal. Tout changement ou modification non approuvé expressément par la partie responsable pourrait annuler le droit à l'utilisateur de faire fonctionner cet équipement. One Year Limited Warranty Keep your receipt! Proof of purchase is required for warranty service. WARRANTOR: UNIDEN AMERICA CORP. ("Uniden") ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, subassemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the Operating Guide for this product. STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while this war-ranty is in effect, warrantor will repair the defect and return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representatives in connection with the performance of this warranty. THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in this Operating Guide, you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). Include evidence of original purchase and a note describing the defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable means, or delivered, to warrantor at: Uniden America Corporation C/O Saddle Creek 743 Henrietta Creek Rd., Suite 100 Roanoke, TX 76262 POP Mode is a trademark of MPH Industries, Inc. Issue 1, March 2016