Viking VDD5360 VDVE900 - 900 CFM Exterior Power Ventilator - Installation Inst - Page 3
Install The Blower
View all Viking VDD5360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INSTALL THE BLOWER ROOF INSTALLATIONS INSTALL THE BLOWER WALL INSTALLATIONS 1. Remove roofing nails from the upper 2/3 of the shingles around the cutout area and carefully lift the shingles to allow the back flashing sheet on the blower housing to fit under them. 2. Center the blower ring in the 11" diameter hole, making sure that the 1-1/4" diameter electrical wiring hole aligns with the hole in the wiring box. 3. Attach the blower to the roof with the six screws provided. All six holes in the back panel must be filled, or any moisture that may get inside the blower housing could leak into the house. 4. Using a good grade of roofing cement, seal all of the shingles around the housing and flashing sheet as well as the mounting screw heads. 1. Place a large bead of caulk on the back side of the housing along the outer edge. 2. Center the blower ring in the 11" diameter hole, making sure that the 1-1/4" diameter electrical wiring hole aligns with the hole in the wiring box. 3. Attach blower to the wall with the six screws provided. All six holes in the back panel must be filled, or any moisture that may get inside the blower housing could leak into the house. 4. Using a good grade of caulk, seal all around the mounting screw heads. 5. Bring electrical wiring through the hole in the wiring box and secure it according to local codes. 5. Bring electrical wiring through the hole in the wiring box and secure it according to local codes. Figure 4 6. Make the electrical connections with the proper connector for the type of wire being used. Connect white to white, black to black, and green or bare wire to green. See Figure 4. BLACK TO BLACK 7. Replace wiring box cover and screws. Do not pinch wiring under cover. 8. Check for free movement of the damper before installing housing cover and screws. DOWL1LF2IINRNN0EODEVARMIINNCAFT ELECTRICAL PANEL WHITE TO WHITE GREEN TO GREEN 9. Top and side flanges of the back plate may be covered with trim strips. Do not block grille opening at bottom with trim. It will adversely affect performance of the blower. 10. See downdraft manual for instructions to connect wiring to downdraft electrical panel. 6. Make the electrical connections with the proper connector for the type of wiring being used.Connect white to white, black to black, and the green or bare wire to green. See Figure 4. 7. Replace wiring box cover and screws. Do not pinch wiring under the cover. 8. Check for free movement of the damper before installing housing cover and screws. 9. See downdraft manual for instructions to connect wiring to downdraft electrical panel. 3