Viper 3002 Owner Manual - Page 16
programming 2-way remote - remote start
View all Viper 3002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
programming 2-way remote To enter programming mode Press and hold all four remote control buttons simultaneously until one long beep is heard. Programming mode is now entered. Beeps On/Off Press to select beeps On/Off. One beep is notification beeps On, Two beeps is notification beeps Off. The notification beeps are programmed On from the factory and can be programmed Off if they are not desired. When programmed Off the remote will only flash the LEDs as notification of a command page or an alarm page. 2-Way LED Remote battery low notification Press to select low battery notification On/Off. One beep is low battery notification On. Two beeps is low battery notification Off. The Low battery Beeps are programmed On from the factory and can be programmed Off if they are not desired. When programmed Off the remote will not give any notification that the battery charge level in the remote is low. Page notification The remote control can be programmed to notify the user of a page (audibly beeping if the vehicle's status changes, e.g. door unlocked, engine started, vehicle violation, etc.). On the 2-way LED remote press to select page On/Off. One beep is page On, Two beeps is page Off. When programmed off the remote will not give any notification that a page was received from the vehicle. © 2006 directed electronics 17