Viper 4204 Owner Manual - Page 24

by the installer (default 6 starts). Timer Start is exited after the final start. Smart Start operation Smart Start uses the settings for Timer Start in addition to temperature and battery level to automatically start the engine. Activation begins the countdown timer. When the timer expires the vehicle interior temperature and battery level is checked and, if the Temperature is above 100F, below 0F, or the battery level is below 10.5v, the engine will start. When the Remote start runtime expires the engine shuts off, and the countdown timer restarts. Smart Start is exited after the final start. Note The temperature and battery thresholds can be changed by an authorized Directed dealer if a higher or lower threshold is desired. Temperature Reporting During Remote start the vehicle interior is checked regularly for temperature changes. If a change in temperature is detected this report will be sent to the remote for display. Each time the remote receives this report it will beep and display the temperature as described for the Temperature Request in the Advanced Commands section Level 1. Note Temperature report must be turned on by an authorized Directed dealer. Remote Start Time-out Alert During remote start a message is sent three minutes before and again at one minute before the engine turns off. The LED, Remote Start LED flash and several tones play as an alert to reset the runtime if desired. © 2011 Directed Electronics. All rights reserved. 21