Vtech Go Go Smart Wheels Fire Station User Manual - Page 5
Getting Started
View all Vtech Go Go Smart Wheels Fire Station manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Unlock the packaging locks: Rotate the packaging locks counter-clockwise. Pull out the packaging locks and discard them. ASSEMBLY INSTRUCTIONS Connect the short track piece to the main unit near the recognition sensor as shown. Getting Started GETTING STARTED BATTERY INSTALLATION 1. Make sure the unit is turned OFF. 2. Locate the battery cover on the bottom of the main unit. Use a coin or a screwdriver to loosen the screw. 3. Install 2 new 'AA' (AM-3/LR6) batteries following the diagram inside the battery box. (The use of new alkaline batteries is recommended for maximum performance.) 4. Replace the battery cover and tighten the screw to secure. 128500 IM.indd 5 5 2013/8/20 15:38:39
5
Getting Started
Rotate the packaging locks counter-clockwise.
Pull out the packaging locks and discard them.
Unlock the packaging locks:
ASSEMBLY INSTRUCTIONS
Connect the short track piece to the
main unit near the recognition sensor
as shown.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned
OFF
.
2. Locate the battery cover on the
bottom of the main unit. Use a coin or
a screwdriver to loosen the screw.
3. Install 2
new
‘AA’ (AM-3/LR6)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for
maximum performance.)
4.
Replace the battery cover and tighten
the screw to secure.
128500 IM.indd
5
2013/8/20
15:38:39