Vtech KidiZoom Smartwatch DX2 User Manual - Page 5
WARNING, GETTING STARTED, Master Power Switch
View all Vtech KidiZoom Smartwatch DX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
WARNING: Prolonged wear of any watch can cause skin irritation for some people. Clean the watch band regularly by wiping it with a damp towel. Be careful not to get the watch wet, as this could damage the unit. Do not use soaps or household cleaners, as they can get trapped under the band and irritate the skin. Always dry the band before putting it back on. Irritation can also occur if the band is too tight or too loose. If redness, swelling, itchiness, or any other irritation occurs, remove the watch and consult a physician. GETTING STARTED Master Power Switch When you use KidiZoom® Smartwatch DX2 for the first time, you will need to slide the Master Power Switch (located on the underside of the watch) to the ON position . You may need a small tool such as a paper clip to move the switch to the on position. Then, fully charge the watch before first use. A full charge will take about 3 hours. When the Master Power Switch is set to the OFF position, the unit will not function and the battery will not charge. Only move the switch to the OFF position when the watch will not be used for an extended period of time. Note: It is not necessary to switch off the watch in daily use. Once the master power switch is off, the watch will stop functioning and after it is turned on again, the time and date has to be reset. BATTERY RECHARGING Note: Adult operation required. To charge KidiZoom® Smartwatch DX2, the watch needs to be connected to a computer with the included Micro-USB Cable. To do so correctly, please follow these steps: • Make sure that the Master Power Switch is set to the ON position before charging. • Pull up the rubber cover of the Micro-USB Port on the side of the watch. • Insert the Micro-USB Cable (small end) into the Micro-USB Port on the watch. 5