Vtech t2406 User Manual - Page 4
Setup, Connecting power to Base Unit, Installation of Battery Pack in Handset
UPC - 735078006011
View all Vtech t2406 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Setup Connecting power to Base Unit Plug the AC power adapter into an electrical outlet, and the DC connector into the bottom of the Base Unit. Installation of Battery Pack in Handset Follow the steps below: 1. Remove the battery cover by pressing on the indent and sliding downward. 2. With the red and black wires at the bottom of the pack, angle the top of the battery 1 into the compartment, under the two claws. Next, press the lower end of the battery pack down, so it is held in place by the lower claw. Now, plug the connector into the socket. Slip the battery wires into the guide, located below the battery. 3. Replace the battery cover by sliding it upwards. 4. Place the Handset in the Base Unit, and 2 allow it to charge for 12 hours. After the initial charge, a maintenance charge of 8 hours should be sufficient. Maximum talk time on a full charge is approximately 5 hours, and maximum standby time is 5 days. 4