Weber 1100 LP Owner Manual - Page 10

Step 2 Assemble wheels You will need: axle, two wheel hubcaps, two wheels, wheel frame, hammer and a block of wood. Place one end of the axle on the block of wood (or other protected surface). Tap on one hubcap. Put one wheel on the axle, WEBER side toward the hubcap. Slide the axle through the frame. Add the other wheel, WEBER side out. Tap on the hubcap. Figure 1. ER WE B ER WE B Step 3 Assemble top frame You will need: left frame, right frame, two 1/4-20 x 1/2 inch bolts, two nylon washers and a 7/16 inch wrench. Note - Work on carpeted area (on grass or one of the boxes) to protect the finish during frame assembly. Lay the leg pieces as shown so the leg tabs point up. Figure 2. Slip the two frame pieces together with the tabs inside. Figure 2 (a). Slip washers on bolts, insert bolts as shown and tighten. Figure 2 (b). (If you try to insert a bolt and there are no holes, you have the left frame turned the wrong way. Turn the left frame around.) Frame tabs Figure 1 (a) Leg tabs Left frame Right frame (b) Figure 2 10