Weber Genesis 1 LP Owner Manual - Page 14
Step 9, Step 10
View all Weber Genesis 1 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Step 9 Install manifold bracket You will need: manifold bracket Hook the bracket onto the manifold at the center burner valve. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace. Figure 10. Frame brace Manifold bracket Step 10 Install tank panel assembly You will need: tank panel assembly, 1/4-20 x 1 1/4 inch bolt, 1/4-20 hex nut, nylon washer and a 7/16 inch wrench. Insert the tank panel tabs into the slots in the frame brace. Figure 11. Slots in frame brace Frame brace Figure 10 Tank panel tabs Figure 11 Slide tank panel up until notch at bottom of panel fits over the cross brace. Insert one bolt with washer through the hole in the bottom of the tank panel and through the wheel frame. Add hex nut and tighten with the 7/16 inch wrench. Figure 12. Cross brace Figure 12 14