Weber Genesis 1500 LX Owner Manual - Page 13
Assemble the frame, Continue frame assembly
View all Weber Genesis 1500 LX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Step 2 Assemble the frame You will need: left frame, right frame, two nylon washers, two 1/4-20 x 1/2 inch bolts and a 7/16 inch wrench. Note - Work on carpeted area (on grass, or on one of the boxes) to protect the finish during frame assembly. Put the frame pieces so the leg tabs are up. Put the right frame to your right and left frame to your left. Figure 1. Slip the two frame halves together with the tabs inside, until the tabs of the right frame are inside the left frame and the holes align. Figure 1 (a). Slip washers over bolts; insert and tighten bolts. (If you try to insert a bolt and there are no holes, you have the left frame turned the wrong way. Turn the left frame around.) Figure 1 (b). Step 3 Continue frame assembly You will need: frame assembly, two side frames, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench. Assemble one side frame onto the leg tabs of the right frame, and the second side frame onto the leg tabs of the left frame. Make sure the anchoring base plates are facing in toward each other. The tabs must be on the inside of the frames when the joints are closed. Add washers, then bolts. Do not fully tighten these bolts. You will tighten them once the base is anchored. Figure 2 (a). Turn frame assembly right side up. (a) Anchoring base plates are facing in (a) (b) Figure 1 Do not fully tighten these bolts Figure 2 13