Weber Genesis 1500 NG Owner Manual - Page 20
Check for gas leaks, flames in the area while you check
View all Weber Genesis 1500 NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Step 13 Check for gas leaks ƽ DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or death and damage to property. ƽWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Note - All factory made connections have been thoroughly checked for gas leaks. The burners have been flame tested. As a safety precaution you should recheck all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may have loosened or damaged a gas fitting. ƽWARNING: Perform these leak checks even if your barbecue was dealer or store assembled. You will need: soap and water solution and a rag or brush to apply it. To perform leak checks: Turn ON gas supply at the source. Figure 21. Gas supply shut off at the house Check: a) Gas supply line to manifold connection. Figure 22 (a). ƽWARNING: If there is a leak at connection a, retighten the fitting with a wrench and recheck for leaks with soap and water solution. If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact Weber-Stephen Customer Service. b) Valves to manifold connections. Figure 22 (b). c) Barbecue gas supply line to natural gas supply connection. Figure 22 (c). ƽWARNING: If there is a leak at connections b or c, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact Weber-Stephen Customer Service. When leak checks are complete, turn gas supply OFF and rinse connections with water. (a) (b) Figure 21 ƽWARNING: Do not ignite burners while leak checking. Check for leaks by wetting the connections with the soap (c) and water solution and watching for bubbles. If bubbles form or if a bubble grows there is a leak. Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks. Figure 22 20