Weber Genesis 2000 LP Owner Manual - Page 19
Complete accessory installation
View all Weber Genesis 2000 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Position slide bar assembly on the outside of the caster frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 25. Notch to the front Slide bar View from front of barbecue Figure 25 Step 19 Complete accessory installation You will need: two work tables, two accessory trays, Warm-Up Basket, warming rack, thermometer, three tubing plugs and a hammer. Insert one end of the Weber Warm-Up Basket into the hole in the right end of the lid and the other end into the slot in the left end of the lid. Figure 27 (a). Set the work tables onto the left and right side rails. Figure 27 (b). Set the accessory trays between the two frame connectors. Figure 27 (c). Set the warming rack into the slots at the rear of the cooking box. Figure 27 (d). Insert the thermometer into its holder. Figure 27 (e). Insert tubing plugs into the ends of the frame. To fully seat the plugs, you may have to tap them lightly with a hammer. Figure 27 (f). To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 26. (a) (d) (b) (e) (b) Slide Support rod View from rear of barbecue (f) (c) Figure 27 Unlocked position Locked position Figure 26 Caution: To keep the barbecue stationary, the tabs on the locking casters should be in the down position. 19