Weber Spirit E-210 LP Owner Manual - Page 12
Operating Instructions, Troubleshooting - 2 burn
View all Weber Spirit E-210 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 OPERATING INSTRUCTIONS 3) Turn the cylinder on by turning the cylinder valve counterclockwise. 4) Insert match holder with lit match into the matchlight hole in the front of the cooking box. ƽ WARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue. 5) Push Front burner control knob down and turn to START/HI. 6) Check that the burner is lit by looking through the matchlight hole on the front of the cooking box. You should see a flame ƽ WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match. 7) After the FRONT burner is lit you can turn on the other burner. Note: Always light the FRONT burner first.The other burner or burners ignite from the FRONT burner. MAIN BURNER LIGHTING SPIRIT 1 E/SP-210 & 310 TO EXTINGUISH Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply off at the source. 4,6 *The grill illustrated may have slight differences than the model purchased. 2 7 3 5 TROUBLESHOOTING PROBLEM Burners burn with a yellow or orange flame, in conjunction with the smell of gas. Symptoms: Burners do not light. -or- Burners have a small flickering flame in the HI position. -orBarbecue temperature only reaches 250˚ to 300˚ in the HI position. Burner does not light, or flame is low in HI position. Experiencing flare-ups: CHECK CURE Inspect Spider / Insect Screens for possible obstructions. Clean Spider / Insect Screens. (See Section "Annual (Blockage of holes.) Maintenance") The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated. Is LP fuel low or empty? To reset the excess flow safety device turn all burner control knobs and the cylinder valve to OFF. Disconnect the regulator from the cylinder. Turn burner control knobs to HI. Wait at least 1 minute. Turn burner control knobs to OFF. Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions". Refill LP cylinder. Is fuel hose bent or kinked? Straighten fuel hose. Does the Left burner light with a match? If you can light the Left burner with a match, then check the Crossover® ignition system. Are you preheating barbecue in the prescribed manner? All burners on high for 10 to 15 minutes for preheating. ƽ CAUTION: Do not line the bottom tray with aluminum foil. Are the cooking grates and Flavorizer® bars heavily coated with burned-on grease? Is the bottom tray "dirty" and not allowing grease to flow into catch pan? Clean thoroughly. (See Section "Cleaning") Clean bottom tray Burner flame pattern is erratic. Flame is low when Are burners clean? burner is on HI. Flames do not run the whole length of the burner tube. Clean burners. (See Section "Maintenance".) Inside of lid appears to be "peeling." (Resembles paint peeling.) The lid is stainless steel, not paint. It cannot "peel". What you are seeing is baked on grease that has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean thoroughly. (See Section "Cleaning".) If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. WWW.WEBER.COM®