Weider 8515 User Manual
Weider 8515 Manual
 |
View all Weider 8515 manuals
Add to My Manuals
Save this manual to your list of manuals |
Weider 8515 manual content summary:
- Weider 8515 | User Manual - Page 1
have questions, or find that there are missing or damaged parts, we will guarantee you complete satisfaction through direct assistance from precautions and instructions in this manual before using this eclUiprnent. Save this manual for futUre' reference. 8515 PATENT PENDING ) 00 00 0 USER'S MANUAL - Weider 8515 | User Manual - Page 2
ASSEMBLY HOW TO USE THE HOME GYM SYSTEM TROUBLESHOOTING AND MAINTENANCE CABLE DIAGRAM ORDERING REPLACEMENT PARTS 2 3 4 5 15 18 19 Back Cover Note: A PART IDENTIFICATION CHART and a PART LIST/EXPLODED DRAWING are attached to the center of this manual. Remove the PART IDENTIFICATION CHART service set - Weider 8515 | User Manual - Page 3
tighten all parts often. Replace any worn parts immediately. 4. Keep small children away from the home gym,system at all times. Always disconnect the lat bar from the home avm system when performing an exercise that does not use the lat bar. . Make sure that the cables remain on the pulleys at all - Weider 8515 | User Manual - Page 4
please review the drawing using the WEIDER® 8515 Home Gym System. If you below and familiarize yourself with the parts that are have additional questions, please call our Customer labeled. ASSEMBLED DIMENSIONS: Height: 74 in. Width: 40 in. Length: 53 in. High Pulley Station Lat Bar Butterfly Arms - Weider 8515 | User Manual - Page 5
instructions: • Place all parts of the WEIDER 8515 in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. • The assembly is divided into four stages: 1) frame assembly, 2) press and butterfly arm assembly, 3) cable and pulley assembly - Weider 8515 | User Manual - Page 6
used in steps 1 through 3. 4. Press two 1 1/2" Bushings (82) into the Left Pedal (79). Attach a Pedal Cover (81) to the Left Pedal with a 1/2" Metal Screw (77). Assemble the Right Pedal (not shown) in the same manner. 3 27 3 56 4 11 55 44 3 79 11 er _44 49 Crossbar 42 81 0 82 6 - Weider 8515 | User Manual - Page 7
80 7 80 78 78 Slotted Brackets 79 69 70 56-Lubricate 80 85 8 6 -\T -1 84 - i 56 < 79 8. Set two Weight Bumpers (19) onto the brack- 8 et on the Base (4) as shown. Stack six Weights (25) onto the Weight Bumpers (19). Be sure that the pin grooves are all on the same side and that the - Weider 8515 | User Manual - Page 8
Weight. Lubricate the inside of the holes in the Top Weight (76). Set the Top Weight onto the stack of Weights (25). Insert both Weight Guides (62) into the stack of Weights. Be sure that the holes in the Weight Guides in the Base. Be sure that the pulleys are on the indicated side. Lubricate the - Weider 8515 | User Manual - Page 9
(17) with two 5/16" x 2 1/2" Bolts (22) and two 5/16" Nylon Locknuts (3). Assemble the other Press Arm (46) in the same manner. 44 31 49 46 22 3 17 46 Right Arm with the Left Arm (47); note the posi- tion of the "V" Pulley (6) to identify the Right Arm. Be sure that the upper end of the Right - Weider 8515 | User Manual - Page 10
you assemble the cables and pulleys in steps 14 through 22, please refer to the CABLE DIAGRAM on page 19 of this manual. 14. Route the Long Cable (23) around the 3 1/2" Pulley (15) attached to the Top Frame (55). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley - Weider 8515 | User Manual - Page 11
18. Route the Long Cable (23) around the 3 1/2" Pulley (15) attached to the bracket on the Top Frame (55). Tighten the 3/8" x 2" Bolt (12) and the 3/8" Nylon Locknut (21). (Note: This Pulley is pre-assembled. It has been shown disassembled for easy part identification.) Be sure that the Cable is in - Weider 8515 | User Manual - Page 12
Washer (10). Do not com- pletely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns. Attach the Small "U"-Bracket (67) to the Weight Tube (63) with the 5/16" x 1 3/4" Bolt (72) and a 5/16" Nylon Locknut (3). 3 10 2 23 72 67 63 0 23. Attach the - Weider 8515 | User Manual - Page 13
25. Press a 1 1/2" Square Inner Cap (32) into the 25 Leg Lever (29). Lubricate the 5/16" x 2 1/4" Bolt (33). Attach the Leg Lever (29) to the Seat Frame (36) with the 5/16" x 2 1/4" Bolt and a 5/16" Nylon Locknut (3). Insert the 5/16" x 2" Eyebolt (35) into the Leg Lever (29) from the direction - Weider 8515 | User Manual - Page 14
home gym system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM - Weider 8515 | User Manual - Page 15
HOW TO USE THE HOME GYM SYSTEM The instructions below describe how each part of the home gym system can be adjusted. Refer to the exercise poster accompanying this manual to see how the home gym system should be set up for each exercise. IMPORTANT: When attaching the lat bar or nylon strap, make - Weider 8515 | User Manual - Page 16
Set the bracket on the Seat Frame (36) onto the indicated pins on the Front Upright (42). Attach the Seat Frame to the Front Upright with the 5/16" x 2 3/4" Carriage Bolt (14) and the Seat Knob (40). For some exercises 42). ATTACHING THE LEG LEVER TO THE LOW PULLEY STATION To use the Leg Lever (29), - Weider 8515 | User Manual - Page 17
plates. The butterfly arm resistance listed is the resistance for each butterfly arm. WEIGHT PLATES PRESS ARM (lbs.) BUTTERFLY ARM (lbs.) LEG LEVER HIGH PULLEY LOW PULLEY (lbs.) (lbs.) (lbs.) Top 20 1 45 2 70 3 99 4 128 5 153 6 184 10 15 14 24 22 36 28 54 33 54 44 - Weider 8515 | User Manual - Page 18
TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts often and replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES 1 Woven cable, the type of cable used on the home gym - Weider 8515 | User Manual - Page 19
CABLE DIAGRAM The cable diagram below shows the proper routing of the Short Cable (58) and the Long Cable (23). Use the diagram to be sure that the two cables have been assembled correctly. If the cables have not been correctly routed, the home gym system will not function properly and damage may
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
 |
 |
8515
PATENT
PENDING
Model
No.
WESY85150
Serial
No.
Write
the
serial
number
in
the
space
above
for
future
reference.
0
0
0
Serial
Number
Decal
QUESTIONS?
As
a
manufacturer,
we
are
com-
mitted
to
providing
complete
customer
satisfaction.
If
you
have
questions,
or
find
that
there
are
missing
or
damaged
parts,
we
will
guarantee
you
complete
sat-
isfaction
through
direct
assis-
tance
from
our
factory.
TO
AVOID
UNNECESSARY
DELAYS,
PLEASE
CALL
DIRECT
TO
OUR
TOLL
-FREE
CUSTOMER
HOT
LINE.
The
trained
techni-
cians
on
our
customer
hot
line
will
provide
immediate
assis-
tance,
free
of
charge
to
you.
CUSTOMER
HOT
LINE:
1-800-225-0653
Mon.
—Fri.,
6
a.m.-6
p.m.
MST
CAUTION!
Read
all
precautions
and
instruc-
tions
in
this
manual
before
using
this
eclUiprnent.
Save
this
manual
for
futUre'
reference.
)
0
00
00
USER'S
MANUAL