Weider B120 Bench Assembly Instructions - Page 4
Loosen, Remove
View all Weider B120 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
O 0 wbrocke 2 0 crossnmilber 0 11 d h 0 • O 3 O 0 STEP 1 - FRAME ASSEMBLY Begin by inserting 2 SQUARE PLASTIC CAPS (d) into UPRIGHT (1). Align bolt holes on L-BRACKETS (11) with bolt holes on UPRIGHT (1). Secure each bracket with 2 HEX HEAD BOLTS (h) and 2 LOCK NUTS (j). Align bolt hole on MAIN FRAME (2) and FRONT SUPPORT (3). Secure with 1 HEX HEAD BOLT (h) and 1 LOCK NUT (j). With UPRIGHT (1) standing, lower u-bracket of MAIN FRAME (2) onto crossmember of UPRIGHT (1). Align bolt holes and secure with 2 HEX HEAD BOLTS (m) and 2 LOCK NUTS (j). Insert 2 SQUARE PLASTIC CAPS (e) into FRONT SUPPORT (3). Tighten all bolts. LOOSEN 1 OR 2 TURN REMOVE O NOTE: The lower or attachment end of the BACKREST (5) can be identified quickly by the LONG ANGLE IRONS (10). The LONG ANGLE IRONS (10) will be extended approximately two inches beyond the BACKREST PAD (5). STEP 2 - BACKREST PREPARATION Turn BACKREST (5) over to expose work area. Both LONG ANGLE IRONS (10) have been fastened to BACKREST 5) for shipment. One long angle iron must be loosened in order to assemble BACKREST (5) to main frame pivot rod. The lower MACHINE SCREW (k) must be removed while the upper MACHINE SCREW (k) is only loosened. The LONG ANGLE IRON (10) can now swing freely from the lower end of BACKREST (5). 3