Weider B121bronze Medallion Bench English Manual - Page 5
Tacres
View all Weider B121bronze Medallion Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
WV 0 OSZAL Lac..43-scu ',. 0 D • 0 • deloj ite. DETAIL A 0 STEP 3 - ATTACHING BACKREST b SEAT BACKREST: To aid in attaching Tacres ; first slide the. BACKREST ADJ. BAR (9) through one of the hole patterns in the uprights. With LONG ANGLE IRON (10) free, lower BACKREST (5) to main frame pivot rod. Slide the secured LONG ANGLE IRON (10) onto one side of pivot rod. Swing the free LONG ANGLE IRON (10) back to its original position and onto the opposite end of the pivot rod. See Detail A. Replace MACHINE SCREW (k) that was removed in Step 2 and tighten all machine screws. SEAT: With SEAT (6) right-side up, lower SEAT (6) to MAIN FRAME (2). Trign bolt holes and fasten with 2 MACHINE SCREWS (K) and 2 FLAT WASHERS (P). Tighten all machine screws. 0 4 STEP 4 - ATTACHING LEG CURL LEG CURL BRACKETS (11 e * A 7 O _ 10 Place LEG CURL (4) between leg curl brackets on main O frame and align bolt holes. Secure with HEX HEAD BOLT (F) and LOCK NUT (G). Repeat the following instructions until all PAD BARS (7) and FOAM PADS (8) are in place. First slide PAD BAR (7) through proper bole in LEG CURL(4) until equal amounts of bar are on both sides of LEG CURL (4). Apply a small amount of liquid dish detergent to both ends of PAD BAR (7) to aid in the following step. Slide FOAM PAD (8) onto each end of PAD BAR (7) and insert ROUND PLASTIC CAP (A) into each end of PAD BAR (7). Insert SQUARE PLASTIC CAP (E) into end of LEG CURL (4). Insert ROUND PLASTIC CAP (B) into weight pin on LEG CURL (4). Place COVER CAP (C) over rear extended piece of weight pin. 4