Weider Pro 875 Bench English Manual - Page 8
Tighten all of the M10 Nylon Locknuts 36
View all Weider Pro 875 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Lubricate the M10 x 178m Bolt (46). Attach the Right and Left Backrest Frames (7, 8) to the Frame (2) with the Bolt, two M10 Washers (41), and an M10 Nylon Locknut (36). Align an adjustment hole in the Right and Left Backrest Frames (7, 8) with the indicated hole in the Frame (2). Insert the Backrest Pin (26) through the Frame and the Backrest Frames, and secure it with the Spring Clip (25). Tighten all of the M10 Nylon Locknuts (36) used in steps 1-3. Tighten the four M6 x 38mm Screws (39) used in step 4. 5 Lubricate 46 41 7 26 8 41 36 2 25 6. Press three 45mm Square Inner Caps (22) into the Leg Lever (9). Press a 1" Round Inner Cap (27) into the indicated end of the Weight Tube (15). Attach the Weight Tube (15) to the Leg Lever (9) with the M8 x 58mm Bolt (42), two M8 Washers (43), the Spacer (30), and an M8 Nylon Locknut (44). Press the 1" Angled Cap (28) onto the back of the Weight Tube. Lubricate an M10 x 72mm Bolt (45). Attach the Leg Lever (9) to the Front Leg (1) with the Bolt and an M10 Nylon Locknut (36). Do not overtighten the Nylon Locknut; the Leg Lever must be able to pivot easily. 7. Orient the Seat (11) with the wide end on the side shown. Attach the Seat to the Frame (2) with four M6 x 16mm Screws (37). 6 22 36 9 22 30 42 43 15 27 22 28 43 44 7 11 Wide End 45 Lubricate 1 2 37 37 8