Weslo Aer0bic Glide Plus User Manual - Page 8

IVIAINTENANCE AND TROUBLE-SHOOTING Inspect and tighten all parts of the AEROBIC GLIDE PLUS regularly. Keep the monitor out of direct sunlight or the display may be damaged. The AEROBIC GLIDE PLUS can be cleaned with a soft, damp cloth. Keep liquid away from the monitor. When storing the AEROBIC GLIDE PLUS, remove the batteries from the monitor. HOW TO REPLACE THE BATTERIES If the display of the Monitor (1) becomes dim, the two L1154 watch batteries should be replaced. Lift the Monitor off the Frame (6). Disconnect the Sensor Wire (15) from the 1 Monitor. Remove the four screws from the back cover of the Monitor and remove the back cover (see the inset drawing). Push the two old batteries out of the battery clips, noting which way each battery is turned. Insert two new batteries. Reattach the back cover of the Monitor (1). Connect the 15 Sensor Wire (15) to the Monitor. Insert all excess wire into the Frame (6). Press the Monitor onto the Frame. Screws a Batteries 1 HOW TO ADJUST THE MAGNET AND REED SWITCH If the monitor displays incorrect feedback, the Magnet (27) and Reed Switch (15) should be checked. Pivot the Pedal Frame (32) until the Magnet is aligned with the Reed Switch. Loosen the #8 x 3/4" Screw (18). Slide the Reed Switch sideways until there is a 1/8" gap between the Reed Switch and iiie Magnei. Tignien the WEI x 3/V Screw. 32 27 15 15 18 32 27 HOW TO LUBRICATE THE AEROBIC GLIDE PLUS Every three months, a small amount of light multi-purpose oil should be applied to the AEROBIC GLIDE PLUS. Apply a few drops of oil between the dome caps and the frame in the locations shown at the right. Make sure to apply oil to both sides of the AEROBIC GLIDE PLUS. Apply Oil 8