Weslo Cadence 1000 Treadmill English Manual - Page 8
secure location.
View all Weslo Cadence 1000 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
IF THE WALKING BELT HAS SHIFTED TO THE RIGHT: Turn the left adjustment bolt counterclockwise, and the right adjustment bolt clockwise, 1/8 of a turn at a time, until the walking belt is centered. IF THE WALKING BELT SLIPS DURING USE: Turn both adjustment bolts clockwise until the belt no longer slips. Be careful to keep the belt centered. Do not overtighten the bolts. This may cause stretching of the belt, excessive roller noise, and reduced motor performance. To check the walking belt for proper tension, UNPLUG THE POWER CORD, and lift the edges of the walking belt. You should be able to raise each edge 2-3 inches off the walking platform. The center of the belt should remain just at the surface of the platform. 2"-3" The alien wrench can be stored conveniently on the selfadhesive wrench clip included. ROLLER GUARD ADJUSTMENT Roller Bracket 0 O Wrench Clip The roller guards should be positioned so that the rear edges are 1/8 inch away from touching the rear roller. To adjust the roller guards, loosen the screws in the roller guards, slide the roller guards forward or backward, and retighten the screws. Roller Guard 6 Rear Roller CIRCUIT BREAKER If the treadmill stops or will not start, check the circuit breaker located on the front of the frame near the power cord. The circuit breaker is designed to protect the electrical system. If the circuit breaker has tripped, the switch will protrude as shown. To reset the circuit breaker, allow the treadmill to cool for a few minutes, MOVE THE SAFETY KEY TO THE OFF POSITION and push the switch back in. Tripped Reset STORAGE Always unplug the power cord when the treadmill is not in use. To convert thertreadmill to the storage position, first remove the screws and washers from the lower and upper ends of the side rail. Store the • screws and washers in a secure location. Loosen the lock knob and lay the upright post on the treadmill. Lay the side rail on the treadmill. Always remove the battery from the electronic monitor 8 when storing the treadmill for extended periods of time.