Weslo Cadence 3260 Treadmill English Manual - Page 11
permanently
View all Weslo Cadence 3260 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
b. If an extension cord is necessary, use only a 14-gauge general-purpose cord of approximately five feet in length. c. If the walking belt is overtightened, treadmill performance may be reduced and the walking belt permanently damaged. Remove the safety key and UNPLUG THE POWER CORD. With the alien wrench included, turn both rear roller adjustment bolts counterclockwise, 1/4 of a turn. Plug in the power cord and reinsert the safety key. Run the treadmill for a couple of minutes. Repeat until the tension of the walking belt is correct. When the tension is correct, you should be able to lift each side of the walking belt 2-3 inches off the walking platform. The center of the walking belt should just touch the surface of the walking platform. Be careful to keep the walking belt centered on the walking platform. 2"-3" Rear Roller Adjustment Bolts 7. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON a. If the walking belt has shifted to the left, first remove the safety key from the console and UNPLUG THE POWER a. CORD. With the alien wrench included, turn the left rear roller adjustment bolt clockwise, and the right bolt coun- terclockwise, 1/4 of a turn each. Plug in the power cord and reinsert the safety key. Run the treadmill for a cou- ple of minutes. Repeat as necessary until the walking belt is centered. b. If the walking belt has shifted to the right, first remove the safety key from the console and UNPLUG THE POWER CORD. With the alien wrench included, turn the left rear roller adjustment bolt counterclockwise, and the right bolt clockwise, 1/4 of a turn each. Plug in the power cord and reinsert the safety key. Run the treadmill for a cou- ple of minutes. Repeat as necessary until the walking belt is centered. c. c. If the walking belt slips when walked on, first remove the safety key from the console and UNPLUG THE POWER CORD. With the alien wrench included, turn both rear roller adjustment bolts clockwise, 1/4 of a turn. Plug in the power cord and reinsert the safety key. Run the treadmill for a couple of minutes. Repeat as necessary until the tension of the walking belt is correct. When the tension is correct, you should be able to lift each side of the walking belt 2-3 inches off the walking platform. The center of the walking belt should remain just at the surface of the walking platform. Be careful to keep the walking belt centered on the walking platform. The allen wrench can be stored by removing the backing from the wrench clip and pressing it onto one of the roller brackets. Roller Bracket Wrench Clip 11