Weslo Cadence 450 English Manual - Page 6

3. Insert a Plastic Shim (103) into each side of the post on 3 the right side of the Base (11). Next, orient the Right Upright (62) as shown, and insert it into the Base. Make sure that the Wire Harness (21) does not fall into the Right Upright. Be careful to avoid pinching the Wire Harness. Note: If necessary, tap the Right Upright with a rubber mallet until it is fully seated in the Base. If the Right Upright cannot be fully seated, remove the outer Plastic Shim and then insert the Right Upright. Attach the Right Upright (62) to the Base (11) with three 1" Bolts (8) and three Star Washers (9). Do not tighten the Bolts yet. Assemble the Left Upright (not shown) in the same way. 4. Identify the Right Handrail (47), which has a large hole in the left side. Feed the Wire Harness (21) into the hole in 4 the bottom of the Right Handrail and out of the large hole in the left side. (Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the large hole.) Press a Handrail Cap (41) onto the lower end of the Right Handrail as shown. Insert the rectangular bracket on the Right Handrail (47) into the top of the Right Upright (62) so the Handrail Cap (41) is against the Right Upright. Attach the Right Handrail and the Handrail Cap with three 1" Bolts (8) and two Washers (57) as shown. Do not tighten the Bolts yet. Attach the Left Handrail (not shown) as described above. Note: There is not a wire harness on the left side. 5. Hold the Crossbar (34) between the Handrails (1, 47). 5 Attach the Crossbar with two Crossbar Screws (53). Do not tighten the Crossbar Screws yet. Attach the ring on the end of the ground wire to the small 1 hole in the side of the Right Handrail (47) with a Silver Ground Screw (104). 6 21 This hole must be on this side. 62 103 9 8 9 8 11 Large Hole Bracket 47 8 57 8 21 8 57 62 41 Ground 34 Wire 104 53 47 53