Weslo Cadence 78e Treadmill English Manual - Page 10

8. Carefully lower the Left and Right Handrails (22, 8 33) until they are touching the floor. See the lower drawing. Position the Uprights (53, 54) so that the treadmill Frame (51) is centered between the Uprights. Firmly tighten the four Upright Bolts (2) and the two Frame Pivot Bolts (1) used in steps 1 and 3. Be careful not to overtighten the Frame Pivot Bolts. 1 2 51 22, 33 Top View 54 53 51 9. Attach the Latch Housing (48) to the Left Upright (53) with two Latch Screws (7); start both 9 Latch Screws before tightening them. Make sure that the large hole in the Latch Housing is on the indicated side. 48 Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Insert the pin into the Latch Housing (48). Then, tighten the knob onto the pin. Knob 7 Large Hole 53 Spring Collar Pin 10. Raise the Frame (51) to the storage position (see HOW TO FOLD AND MOVE THE TREADMILL on page 15). Attach an Incline Leg (69) to the Frame (51) with an Incline Leg Bolt (32), two Incline Leg Washers (43), and an Incline Leg Nut (46) as shown. Repeat this step on the other side of the Frame (51). Adjust the Incline Legs (69) to the desired level (see HOW TO CHANGE THE INCLINE OF THE TREADMILL on page 14). 10 51 46 43 69 32 43 11. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 18). To protect the floor or carpet, place a mat under the treadmill. 10