Weslo Cadence 78e Treadmill English Manual - Page 8

3. Have a second person lift and hold the front end 3 of the Frame (51). Hold a Frame Spacer (11) be- tween the Right Upright (54) and the Frame. Attach the Right Upright to the Frame with a Frame Pivot Bolt (1), an Upright Washer (14), and an Upright Star Washer (9). Do not tighten the Frame Pivot Bolt yet. Repeat this step on the left side of the treadmill. 4. Set the Console Assembly (91) face down on a soft surface to avoid scratching the Console 4 Assembly. Set the Left Handrail (22) on the Console as shown. Attach the Left Handrail with two Console Screws (10). Attach the Right Handrail (not shown) to the other side of the Console Assembly (91) as described above. 54 11 14 1 9 51 22 10 10 91 5. Hold the Console Assembly (91) near the Right Upright (54). Touch the Right Handrail (33) to 5 discharge any static. Remove the wire from the end of the Wire 91 Harness (39). Insert the end of the Wire Harness through the large holes in the bottom and side of the Right Handrail (33) and through the two looped plastic ties. Connector Then, press the end of the Wire Harness (39) into the connector on the back of the Console Assembly (91) in the location shown. See the inset drawing. The end of the Wire Harness should slide easily into the connector and snap into place. If it does not, turn the end of the Wire Harness and then insert it. IF THE CONNECTOR IS NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the excess Wire Harness (39) downward into the Right Upright (54). Tighten the two plastic ties around the Wire Harness, and then cut off the ends of the plastic ties. 33 39 54 39 Plastic Ties Connector 39 8