Weslo Cadence 840 Treadmill Canadian English Manual - Page 9
Caution - key
View all Weslo Cadence 840 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
DIAGRAM OF THE CONSOLE Speed Control Display Display Note: If there is a thin sheet of clear plastic on the face of the console, remove it. On/Reset Button Key Pulse Sensor Clip CAUTION: Before operating the console, read the following important precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip while operating the treadmill. When the key is removed from the console, the power will shut off. • After the speed control knob is moved, there will be a pause before the walking belt begins to move. Adjust the speed in small increments until you are familiar with the treadmill. • To reduce the risk of electric shock, keep the console dry, avoid spilling liquids on the console, and use only a sealed water bottle. STEP BY STEP CONSOLE OPERATION Before operating the console, make sure that the power cord is properly plugged in. Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Follow the steps at the right and on page 10 to operate the console. 1 Insert the key fully into the power switch. Note: The displays will not be activated when the key is first inserted, unless batteries were just installed. 2 Press the on/reset button. The two displays will be activated. Note: If batteries were just installed, the displays will already be activated. 3 Reset the speed control and start the walking belt. Slide the speed control fully to the left, to the RESET position. Next, slide the control to the right until the walking belt begins to move at slow speed. Carefully step onto the walking belt and begin walking. Change the speed of the walking belt as desired by sliding the speed control. To stop the walking belt, slide the speed control to the RESET position. 9