Weslo Cadence Dl5 English Manual - Page 8
Caution
View all Weslo Cadence Dl5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
*WLTL21280-146358 5/4/00 11:24 AM Page 8 DIAGRAM OF THE CONSOLE Speed Control Monitor Display Note: If there is a thin sheet of clear plastic on the face of the console, remove it. Keep all liquids away from the console. Key Clip CAUTION: Before operating the console, read the following important precautions. ¥ Do not stand on the walking belt when turning on the power. ¥ Always wear the clip while operating the treadmill. When the key is removed from the console, the power will shut off. ¥ After the speed control is moved, there will be a pause before the walking belt begins to move. Adjust the speed in small increments until you are familiar with the treadmill. ¥ The training zones marked above the speed control are general guidelines only. Read CONDITIONING GUIDELINES on page 12 to determine the proper exercise level. STEP BY STEP CONSOLE OPERATION Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7). Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Follow the simple steps below to operate the console: 1 Insert the key fully into the power switch. Note: The display will not appear when the key is first inserted. Key 2 Press the ON/OFF button. The display will appear. Note: If batteries were just installed, the display will already appear. 3 Reset the speed control and start the walking belt. Slide the speed control fully to the left, to the "SPEED RESET" position. Next, slide the control to the right until the walking belt begins to move at slow speed. Carefully step onto the walking belt and begin walking. Change the speed of the walking belt as desired by sliding the speed control. Note: To stop