Weslo Cadence Ds11 Treadmill Canadian English Manual - Page 9

Caution

Page 9 highlights

DIAGRAM OF THE CONSOLE Displays Speed Control Note: If there is a thin sheet of clear plastic on the face of the console, remove it before operating the console. CAUTION: Before operating the console, read the following precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip (see the drawing below) while using the treadmill. When the key is removed from the console, the walking belt will stop. • Adjust the speed in small increments. • To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Put only sealable water bottles in the water bottle holders. BATTERY INSTALLATION STEP-BY-STEP CONSOLE OPERATION The console requires two 12 "AA" batter- ies (not includ- ed). Alkaline batteries are Batteries recommended. To install bat- 12 teries, open the battery cover (12) beneath the Tab console as shown. Press two batteries into the console. Make sure that the negative (-) ends of the batteries are touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown in the inset drawing. Make sure that the tab locks into place. Before operating the console, make sure that the power cord is properly plugged in (see page 8). Note: To prevent damage to the walking platform, always wear clean shoes when using the treadmill. Step onto the foot rails of the treadmill. Find Key the clip attached to the key, and slide the clip onto the waist- band of your clothes. Next, Clip insert the key fully into the con- sole. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19

CAUTION:
Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turning
on the power.
• Always wear the clip (see the drawing below)
while using the treadmill. When the key is
removed from the console, the walking belt
will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids on
the console. Put only sealable water bottles in
the water bottle holders.
BATTERY INSTALLATION
The console
requires
two
“AA” batter-
ies
(not includ-
ed). Alkaline
batteries are
recommended.
To install bat-
teries, open
the battery
cover (12)
beneath the
console as
shown. Press
two batteries into the console.
Make sure that the
negative (–) ends of the batteries are touching the
springs.
Close the battery cover, push up on the tab,
and then push the tab forward as shown in the inset
drawing. Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 8).
Note: To prevent damage to the walking platform,
always wear clean shoes when using the treadmill.
Step onto the
foot rails of the
treadmill. Find
the clip attached
to the key, and
slide the clip
onto the waist-
band of your
clothes. Next,
insert the key
fully into the con-
sole.
Test the clip by carefully taking a few steps
backward until the key is pulled from the console.
If the key is not pulled from the console, adjust
the position of the clip as needed.
DIAGRAM OF THE CONSOLE
Speed Control
Displays
Batteries
12
Note: If there is a thin sheet of clear plastic
on the face of the console, remove it before
operating the console.
Clip
Key
Tab
12
9