Weslo Cadence Dx10 Canadian English Manual - Page 9

DIAGRAM OF THE CONSOLE Displays On/Reset Button Speed Control Pulse Sensor Clip Key CAUTION: Before operating the console, read the following precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop. • Adjust the speed in small increments. • To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle. BATTERY INSTALLATION The console requires three "AA" batteries (not included); alkaline batteries are recommended. Open the Battery Cover Batteries Battery Cover Tab battery cover and press the batteries into the console; the negative (-) ends of the batteries must touch the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown in the inset drawing. Be sure that the tab locks into place. STEP BY STEP CONSOLE OPERATION Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 8.) In addition, make sure that batteries are installed in the console. If there is a thin sheet of clear plastic on the console, remove it. Step onto the foot rails of the treadmill. Next, find the clip attached to the key (see the drawing above). Slide the clip onto your waistband. Follow the steps below and on page 10 to operate the console. 1 Insert the key fully into the power switch. Note: Inserting the key will not turn on the displays. The displays will turn on when the display on/reset button is pressed or when the walking belt is started. If you just installed batteries, the displays will already be on. 9