Weslo Cadence G25 Treadmill English Manual - Page 7

3. With the help of a second person, raise the Handrails 3 (6, 7) so the Base (71) is flat on the floor as shown. 7 Attach the Wheels (15) to the outer sides of the Base (71) with two Wheel Bolts (14) and two Nuts (17) as shown. Do not overtighten the Nuts; the Wheels should turn freely. Position the front of the treadmill Frame (55) between the Handrails (6, 7) as shown. Next, locate the long wire inside of the lower end of the Right Handrail (see the inset drawing). Secure the end of the wire to the end of the Wire Harness (22) using the included plastic tie. Then, pull the other end of the wire until the end of the Wire Harness is extending from the upper end of the Right Handrail. 6 17 15 55 22 14 71 Wire Tie 22 6 4. Have a second person lift and hold the front end of the Frame (55). Hold a Frame Spacer (13) between the Right 4 Handrail (6) and the Frame. Attach the Right Handrail to the Frame with a Frame Bolt (10), a Handrail Washer (30), and a Handrail Star Washer (60). Repeat this step on the left side of the treadmill. 5. Hold the Console Base (1) near the Right Handrail (6). 5 Touch the Right Handrail to discharge any static. Insert the end of the Wire Harness (22) through the three looped plastic ties. Next, press the end of the Wire Harness into the connector on the back of the Console Base (1) in the location shown. The end of the Wire Harness should slide easily into the connector and snap into place. If it does not, turn the end of the Wire Harness and then try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. 7 6 13 30 10 60 55 Connector 1 22 Plastic 6 Ties 22