Weslo Cadence Ls 8 English Manual - Page 6
Attach the Storage Catch 80 and the Catch Spacer
View all Weslo Cadence Ls 8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. Attach the Console Base (12) to the Handrails (30, 32) with four Screws (48). 3 Feed the excess Wire Harness (28) into the upper end of the Right Handrail (32). 28 Tighten all parts used in steps 2 and 3. 4. Attach the Storage Catch (80) and the Catch Spacer (44) to the left side of the Frame (76) with four Screws 4 (48). Be careful not to overtighten the Screws. Make sure that the Storage Catch and the Catch Spacer are turned as shown. 12 48 32 30 48 80 48 44 76 5. Remove the backing from the Wrench Clip (91). Press the Wrench Clip onto the base of the right Upright (31) in 5 the indicated location. Press the Allen Wrench (90) into the Wrench Clip. Feed the excess Wire Harness (28) into the right Upright (31). 31 28 90 91 6. The console requires two "AA" batteries (not included). Alkaline batteries are recommended. To install batteries, open the battery cover as shown at the right. Press the batteries into the battery compartment, with the negative (Ð) ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown in the inset drawing. Be sure that the tab locks into place. 7. Make sure that all parts are tightened before you use the treadmill. Note: The ratchet screws are factory set and should not be adjusted. To protect the floor or carpet, place a mat under the treadmill. 6 Battery Cover Batteries 7 Ratchet Screws Battery Cover Tab 6