Weslo Momentum 4.8 Elliptical English Manual - Page 8
See the inset drawing., Tip: Avoid pinching the wires., Attach the other Link Arm KK to the Left,
View all Weslo Momentum 4.8 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
6. Route the Resistance Knob Cable (W) downward through the Upright (T) as shown. 6 Then, attach the Resistance Knob (V) to the Upright (T) with an M5 x 15mm Screw (CC). Z Y See the inset drawing. While another person holds the Upright (T) near the Frame (A), tie the Wire Tie (Y) in the Upright securely around the end of the Sensor Wire (Z). Next, pull the other end of the wire tie until the Sensor Wire is routed completely through the Upright. Then, connect the Resistance Knob Cable (W) to the Hook (U) on the Resistance Cable (X). Tip: Avoid pinching the wires. Attach the Upright (T) to the Frame (A) with two M8 x 57mm Bolts (AA), two M8 Curved Washers (E), and two M8 Locknuts (BB). V CC W T W X BB A E W T U AA X Y A Z 7. Attach a Link Arm (KK) to the Right Crank Arm 7 (P) with an M8 x 18mm Bolt (EE), an M8 Plastic Washer (G), an M8 Flat Washer (DD), and an M8 Locknut (BB). Attach the other Link Arm (KK) to the Left Crank Arm (Q) in the same way. KK EE G DD Q BB G KK BB DD EE P 8