Whirlpool CGM2941TQ Installation Instructions - Page 11

4. Iftheburnedroesnotigniteandyoucanfeelnoheaitnside thedryers,huot ffdryefrorfiveminuteCs.hectkhatallsupply valvecontrolasrein"ON"positioanndthattheelectriccaol rd ispluggeidn.Repeafitve-minutteest. 5. Ifdryintgimeistoolongm, akesurelintscreeinsclean. INSTALLATIOINNSTRUCTION-SELECTRICDRYER The console houses the factory-installed accumulator timer with actuating arm and button. The timer installed is set to provide 45 minutes (4 pins) of drying time when activated by the coin slide. Timer cams for 30-minute (6 pins) and 60-minute (3 pins) drying times are included in the parts bag. The coin-slide mechanism, control panel lock and key, and coinbox lock and key are not included and are available from usual industry sources. Excessive Weight Hazard Use two or more people to move and install dryer. Failure to do so can result in back or other injury. For dryers using coin slides, use adapter kit supplied with dryer. 7. Replace the meter case service door. Put the coin vault with lock and key in the meter case opening. 8. Remove cardboard or hardboard from under dryer. Power Supply Cord Method This dryer is manufactured with the neutral ground wire connected to the neutral (center) of the wiring harness at the terminal block. If local codes do not permit this type of connection, use "Four-wire connection" instructions. Use a new UL-listed power supply cord rated 240-volt min., 30-amp and marked for use with a clothes dryer. NOTE: Slide dryer onto cardboard or hardboard before moving to avoid damaging floor covering. t. Using two or more people, move dryer to desired installation location. 2. Take tape off front corners of dryer. Open dryer and remove the literature and parts packages. Wipe the interior of the drum thoroughly with a damp cloth. 3. Take two of the cardboard corners from the carton and place them on the floor in back of the dryer. Firmly grasp the body of the dryer and gently lay it on its back on the cardboard corners. 4. With one of the legs in hand, check the ridges for a diamond marking. That's how far the leg is supposed to go into the hole. 5. Start to screw the leveling legs into the holes by hand. (Use a small amount of liquid detergent to lubricate the screw threads so it is easier to turn the legs.) Use a 1-inch wrench or socket wrench to finish turning the legs until you reach the diamond mark. Now stand the dryer up. 6. Remove the service door of the meter case by lifting it up at the back. Install the money-accepting device. (Refer to manufacturer's instructions for proper installation.) Fire Hazard Use a new UL listed 30 amp power supply cord. Use a UL listed strain relief, Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green ground connector. Connect remaining 2 supply wires to remaining 2 terminals (gold). Securely tighten all electrical connections. Failure to do so can result in death, fire, or electrical shock. t. Disconnect power. 11