Whirlpool EED4100SQ Installation Instructions - Page 2

Location Requirements WARNING Dryer Dimensions 43 ³⁄₈" (110 cm) 15¼" (38.74 cm) 43 ³⁄₈" (110 cm) 22 ¾" (57.8 cm) Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. You will need s A location that allows for proper exhaust installation. See "Venting Requirements." s A separate 30-amp circuit. s If using a power supply cord, a grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See "Electrical Requirements." s A sturdy floor to support the total weight (dryer and load) of 200 lbs (90.7 kg). The combined weight of a companion appliance should also be considered. s A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet Kit, Part Number 279810.) Clothes may not tumble properly and models with automatic sensor cycles may not operate correctly if dryer is not level. Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector. Installation Clearances The location must be large enough to allow the dryer door to open fully. *26" (66 cm) 29" (73.66 cm) A *27 ¾" (70.5 cm) 29" (73.66 cm) B 43 ³⁄₈" (110 cm) 22 ¾" (57.8 cm) 43³⁄₈" (110 cm) 13 ¾" (34.9 cm) *27 ¾" (70.5 cm) 29" (73.66 cm) C *27 ¾" (70.5 cm) 29" (73.66 cm) D A. Small opening side-swing door B. Large opening side-swing door C. Wide opening side-swing door D. Wide opening hamper door *Most installations require a minimum 5½" (14 cm) clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements." Minimum installation spacing for recessed area or closet installation The dimensions shown following are for the minimum spacing allowed. s Additional spacing should be considered for ease of installation and servicing. s Additional clearances might be required for wall, door and floor moldings. s For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. s Companion appliance spacing should also be considered. 18" (45.7 cm) 14" max. (35.6 cm) 48 in. 2 (310 cm2) 3" (7.6 cm) 24 in.2 (155 cm2) 0"* 29" 0"* 0"* 27¾" 5½" (0 cm) (73.66 cm) (0 cm) (0 cm) (70.5 cm) (14 cm) A B C A. Recessed area B. Side view - closet or confined area C. Closet door with vents *Additional spacing recommended 3" (7.6 cm) 2