Whirlpool GSC308PRQ Installation Instructions - Page 3
Installation Instructions
View all Whirlpool GSC308PRQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INSTALLATION INSTRUCTIONS Prepare Oven for Installation 1. Decide on the final location for the oven. Locate existing wiring to prevent drilling into or severing wiring during installation. 4. Remove bottom screw on each side of the oven trim. WARNING A Excessive Weight Hazard Use two or more people to move and install oven. Failure to do so can result in back or other injury. 2. To prevent floor damage, set the oven onto cardboard prior to installation. Do not use handle or any portion of the front frame or trim for lifting. 3. Move oven close to its final location. 4. Remove the shipping materials and tape from the oven. 5. Remove the hardware package from inside the literature bag. 6. Remove and set aside racks and other parts from inside the oven. Remove Oven Trim IMPORTANT: Use both hands to remove oven doors. 1. Open the oven door. 2. Locate the oven door latches in both corners of the oven door, and rotate the latches forward to the unlocked position. A. Remove trim screw and pull out. 5. Grasp the bottom end of trim and pull away from oven. 6. Slide top end of trim downward to remove trim from oven. Set trim aside. Make Electrical Connection A B WARNING A. Oven door latch in locked position B. Oven door latch in unlocked position 3. Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Lift and pull oven door toward you and remove. Set the oven door aside on a protective surface. Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge solid copper wire. Electrically ground oven. Failure to follow these instructions can result in death, fire, or electrical shock. This oven is manufactured with a neutral (white) power supply wire and a cabinet-connected bare ground wire crimped together. 1. Disconnect power. 2. Feed the flexible cable conduit from the oven through the opening in the cabinet. 3. Remove junction box cover if it is present. 4. Connect the flexible cable conduit from the oven to the junction box using a UL listed or CSA approved conduit connector. 5. Tighten screws on conduit connector. 4