Whirlpool GXI6536DXS Use & Care Guide - Page 8

3. Attach a second set of vertical supports (A) and set the vertical height (B). See "Installation Clearances" in the "Location Requirements" section to help determine the desired dimension for vertical height "B." A A B A. Vertical supports B. Vertical height 4. Assemble rubber seals to the front and back flange of the ventilator assembly. 6. Install retainer bracket to both sides and secure with 4 - 4 x 8 mm screws to hold glass canopy to ventilator assembly. A B C A. Retainer bracket B. Glass canopy C. Ventilator assembly 7. Attach the range hood assembly to the upper horizontal support attached to the ceiling using 16 - 4 x 8 mm screws and tighten. A A A. Rubber seal 5. Assemble and center glass canopy to ventilator assembly. B A A. Glass canopy B. Ventilator assembly A. Mounting screws Connect Vent System 1. Install vent system. 2. Push duct over the exhaust outlet. Seal all connections with vent clamps. Non-Vented (recirculating) Installation 1. Attach the air deflector to the upper horizontal support using 4 mounting screws. B A B A. Deflector B. Mounting screws 2. Measure the length of 6" (15.2 cm) duct needed to connect the transition to the deflector. NOTE: Vent should fit up inside the deflector 1" (2.5 cm) minimum. 3. Install vent between the transition and the deflector. NOTE: To make vent installation easier, temporarily remove the deflector from the chimney support bracket and replace after vent section is in place. 4. Seal all connections with vent clamps. 8