Whirlpool LEQ8000JQ User Instructions - Page 3

WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death, - Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance, - WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance, • Do not touch any electrical switch; do not use any phone in your building, • Clear the room, building, or area of all occupants, • Immediately call your gas supplier from a neighbor's phone, Follow the gas supplier's instructions, • If you cannot reach your gas supplier, call the fire department, - Installation and service must be performed by a qualified installer, service agency, or the gas supplier, Your dryer must be properly installed and vented to achieve maximum drying efficiency and shorten drying times. Use the minimum recommended installation clearances (found in your Installation Instructions) to avoid blocking the flow of combustion and ventilation air. See the Installation Instructions for more information. 1. Do not use plastic vent or metal foil vent. Use 4 in. (10.2 cm) metal or flexible metal vent. Do not kink or crush flexible metal vent. It must be completely extended to allow adequate exhaust air to flow. Check vent after installation. Refer to your Installation Instructions for proper length requirements of vent. 2. Use a 4 in. (10.2 cm) exhaust hood. 3. Use the straightest path possible when routing the vent. JJbetter good Fire Hazard Use a heavy metal vent. Do not use a plastic vent, Do not use a metal foil vent. Failure to follow these instructions can result in death or fire. If the dryer is not properly installed and vented, it will not be covered under the warranty. NOTE: Service calls caused by improper venting will be paid for by the customer, whether it was a paid installation or selfinstalled. 4. Use clamps to seal all joints. Do not use duct tape, screws or other fastening devices that extend into the interior of the vent to secure vent. 5. Clean exhaust vent periodically, depending on use, but at least every 2 years, or when installing your dryer in a new location. When cleaning is complete, be sure to follow the Installation Instructions supplied with your dryer for final product check.