Whirlpool UXT4130ADS Installation Guide - Page 6
Installation Instructions
View all Whirlpool UXT4130ADS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
INSTALLATION INSTRUCTIONS NOTES: ■ Depending on your model, determine which venting method to use: roof, wall or non-vented (recirculating). ■ It is recommended that the vent system be installed before the range hood is installed. Go to "Venting System" in the "Installation Requirements" section if you need assistance. ■ Before making cutouts, make sure there is proper clearance within the ceiling or wall for the vent system. 1. Disconnect power 3. Install Brackets WARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 2. Mark Hole Locations ■ Using a #2 Phillips screwdriver, install the drywall anchors. ■ Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws, install the mounting brackets using the upper holes. NOTE: For installations to a surface other than drywall, it is recommended that a qualified contractor determine the anchoring method. 4. Prepare Range Hood Align the exterior edge of the mounting brackets with the exterior edges of the upper cabinet. IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets. ■ Set the range hood on its back on a covered surface. ■ Using a #2 Phillips screwdriver, remove the rectangular damper attached with 3.5 x 9.5 mm screws. ■ Using a #2 Phillips screwdriver, remove the electrical box cover. ■ Using a flat-blade screwdriver, remove the appropriate power supply knockout. 6